Enabling Anesthetic Agent Measurement; Release Mode - Dräger Vamos Operating Instructions Manual

Enabling Anesthetic Agent Measurement

(Release Mode)

The Release Mode can be used to enter the release code to
enable the anesthetic agent measurement option. If the Vamos
is not equipped with this option initially, it can be updated
separately.
To enter Release Mode:
Adjust in the following sequence:
Switch Vamos to Standby Mode with the »
g
Keep pressed the » « key,
Keep pressed the » « key,
g
Release » « key,
Release » « key.
The following information is shown:
fabrication number of the device
device identification number
This information has to be given for ordering the anesthetic
agent measurement option.
After ordering a device specific 10 digit Release code will be
sent by Dräger:
Please, write down the Release code here:
To enter the Release Code:
Turn dial knob to set first digit of Release code
Press dial knob to confirm setting
Repeat this procedure for all digits of the Release code.
After the last digit has been entered Vamos verifies the
entered code. If the correct code has been entered the
following message is shown:
Agent option released
Switch Vamos off and on to enable the option.
If a wrong code has been entered, the following message
is shown:
Wrong Code
g
Press » « key, enter Release Mode again and repeat the
procedure.
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
Enabling Anesthetic Agent Measurement (Release Mode)
Release Mode
« key,
Operation in Measurement Mode
Fab.No. :
AAAA-0000
Device ID : 12345678
Enter Release Code
0 000000000
33