Tesla RoboStar iQ300 Manual page 105


Make sure the GPS on your smartphone is turned on.

Make sure that a third-party application (VPN, antivirus, firewall, etc.) does not block access to
your mobile phone.

Try connecting to another WiFi router or WiFi Hotspot on another mobile phone to eliminate the
error on the Internet connection side.
 You have too many devices connected to your WiFi router or the ability to connect a new device
to it is blocked.
 Turn the WiFi router On and Off.
 Sometimes it is possible to manually connect to its WiFi network labeled „ROBOT ###" while
trying to connect to a robotic vacuum cleaner.
Note: Make sure the charging station is within range of a high quality and strong WiFi signal from your
WiFi router so that it can connect to a WiFi network while charging. The robotic vacuum cleaner also
needs this WiFi connection during its charging to be properly oriented and available to start cleaning.
Only 2.4 GHz WiFi is supported.
ROBOTIC VACUUM CLEANER FIRMWARE UPDATES
The firmware of the robotic vacuum cleaner is continually improved. If a new firmware version is
available, you will be offered to download the update in the TESLA application and install it in a robotic
vacuum cleaner.
WATER WIPING
Switch off the robotic vacuum cleaner with the „Main switch (3)" and place it away from the charging
station.
Install the blue mop cloth on the bottom of the water
tank. Slightly moisten the mop cloth with water for faster
and smoother water wiping.
When removing the mop from the holder, be careful not
to damage the velcro fastener on the holder quickly.
If the mop is dirty after cleaning, you can wash it
carefully in lukewarm water.