Holzworth Instrumentation HS9000B Series User Manual page 63

Host Software
A variety of host software can be used to communicate with the HS9000B via USB, Ethernet, RS-
232, or GPIB.
Holzworth GUI – The Holzworth provided Multi-Channel application GUI can be used to detect
HS9000B synthesizers connected via Ethernet or USB.
Terminal programs – Any terminal emulation program can be used to communicate with the
HS9000B.
Custom applications – Any programming language or environment which provides network access
can be used to communicate with the HS9000B.
Network Configuration
The HS9000B synthesizers supports static IP address and DHCP. The default setup is DHCP. The
network parameters can be configured using the Holzworth Ethernet Configuration GUI or the
commands listed in the instruction set on the following pages.
In the event the static IP network parameters are incorrectly set and the module cannot be found on
the network, establish a USB connection and use the Holzworth Ethernet Reset GUI to reset the
synthesizer to DHCP mode.
UDP Discovery packets are accepted over port 30303. Send the request "Discovery: Who is out
there?" to receive a list of Holzworth devices on the network.
The HS9000B accepts TCP requests over port 9760. All instructions to the synthesizers or the
HCM5 module should be sent via a TCP socket connection.
TCP data communication can be established using the device IP address or the device host name.
The host name is the complete serial number of the HS9000B synthesizer. An example host name
is HS9005B-309.
www.holzworth.com
HS9000B Series Manual 1.04 Page 61 of 65