Channel Enable Function; Master Select Function - Holzworth Instrumentation HS9000B Series User Manual

8.1.2 Channel Enable Function

The channel enable function allows the user to select which channels are operating. By toggling
the radio button next to the channel number, a user can independently turn each channel on or off.
The example below shows Channel 2 enabled and Channel 1 disabled.

8.1.3 Master Select Function

The Master Select function allows for the user to select channel 1 as being the master control for
any enabled channel. Under this flexible function, channel 1 will always be enabled. The user can
select any combination of Frequency, Power and/or Phase Offset to be controlled via the master
(channel 1). The example below shows the Master Select enabled for frequency and power, with
the result being channel 1 frequency and power applied to channel 2.
NOTE that the GUI does not specifically identify each channel frequency range, but the frequency
limits of each loaded channel is auto-detected and hard set for each channel.
Unavailable Channels
In the case of operating a synthesizer equipped with less than 8 channels, only channels 1 though
N will be displayed for control, the remaining channel slots will not be available.
www.holzworth.com
HS9000B Series Manual 1.04 Page 19 of 65