Appendix B: Ethernet Configuration Commands - Holzworth Instrumentation HS9000B Series User Manual

APPENDIX B: ETHERNET CONFIGURATION COMMANDS

All commands are ASCII commands. One command at a time may be issued over TCP. The ASCII
commands begin with a colon (:) or asterisk (*).
The TCP buffer size is 100 bytes, but the default should be 64 bytes. Bytes sent beyond 64 will be
ignored.
The commands on the following pages relate to the settings on the HCM5 module. To send
commands to the HS9000B synthesizer channels, refer to Appendix B. The same ASCII commands
sent over USB can also be sent over TCP.
If a command is not understood, the module will have in its buffer:
Invalid Command
The format for describing the command instruction is as follows:
:COMMAND:<value>
<value>
Example TX:
RX:
HS9000B Series Manual 1.04
A Description of the command here.
Defined here, if any, queries typically have no value
Example ASCII sent in transmission
Example ASCII received back, if a receive transmission is made
www.holzworth.com
Page 60 of 65