Network Protocol; Ip Address Configuration Commands - 3Com 3031 Command Reference Manual

5
IP Address
Configuration
Commands
display ip interface
ip address
N
ETWORK
Syntax
display ip interface { interface-type interface-number | interface-name }
View
Any view
Parameter
interface-type: Interface type.
interface-number: Interface sequence number.
interface-name: Interface name.
Description
Using the display ip interface command, you can display the running condition of
all the interfaces.
Example
3Com<3Com> display ip interface Ethernet6/0/0
Ethernet6/0/0 current state : UP
Line protocol current state : UP
Internet Address : 5.5.5.5/8
Broadcast address : 0.0.0.0
The Maximum Transmit Unit : 1500 bytes
input packets : 1231, bytes : 57557, multicasts : 1177
output packets : 0, bytes : 0, multicasts : 0
The following information is displayed: the current physical link state of Ethernet
6/0/0 is UP, the protocol of link layer is UP, the IP address is 5.5.5.5, the broadcast
address is 0.0.0.0, the maximum transmit unit is 1500 bytes and some other
information about packets receiving/sending via this interface.
Syntax
ip address ip-address net-mask [ sub ]
P
ROTOCOL