3Com 3031 Command Reference Manual page 514

514 C 5: N
HAPTER ETWORK
dlsw local
P
ROTOCOL
After this command is performed, the system will release all dynamic resources,
but retain the original configuration.
Example
Suspend the DLSw performance.
[3Com] undo dlsw enable
Enable the DLSw performance.
[3Com] dlsw enable
Syntax
dlsw local ip-address [ init-window init-window-size ] [ keepalive keepalive-interval
] [ max-frame max-frame-size ] [ max-window max-window-size ] [ permit-dynamic
]
undo dlsw local ip-address [ init-window ] [ keepalive ] [ max-frame ] [
max-window ] [ permit-dynamic ]
View
System view
Parameter
ip-address: IP address of the created local peer.
init-window-size: Size of the initialized local response window, ranging from 1
to 2000.
keepalive-interval: Time interval for sending the "keepalive", ranging from 0 to
1200 seconds.
max-frame-size: Maximum length of the packet, which can be 516, 1470,
1500, 2052, 4472, 8144, 11407, 11454, or 17800 bytes.
max-window-size: Size of the maximum local response window, ranging from
1 to 2000.
permit-dynamic: Permits unpreconfigured remote router to initiate connections
and dynamically create peers. The remote peer is unnecessarily be configured
on the local end using this parameter, and the local peer waits for the
connection initiated by the remote peer.
Description
Using the dlsw local command, you can create the DLSw local peer. Using the
undo dlsw local command, you can delete the local peer or restore the default
values of the parameters.
The default init-window-size is 40. The default keepalive-interval is 30 seconds.
The default max-frame-size is 1500 bytes. The default max-window-size is 50.
To create the TCP tunnel is the first step for establishing the DLSw connection. In
order to create the TCP tunnel, the DLSw local peer is to be first configured to
specify the local IP address that creates the TCP connection before receiving the
TCP connection request initiated by the remote router. A router can only have one
local peer.