7: Operating the device
7.1: Controlling the device using connected
switches
Controlling connected loads
Input can control output only with the same number (e.g. switch con-
nected to IN1 controls load connected to output OUT1). Perform fol-
lowing actions on inputs to change state of the connected load:
•
1xclick – change to the opposite one (ON/OFF)
•
2xclick – set to 100%
•
hold/release – dimm/brighten
Other actions
•
3xclick – start learn mode to add/remove to/from Z-Wave network
•
1,2,3,4,5xclick/hold/release – activate scene in the controller for
specific action (requires prior configuration)
7.2: Visual indications
The built-in LED light shows current device status.
After powering the device:
•
Green – device added to a Z-Wave network (without Security S2
Authenticated)
•
Magenta – device added to a Z-Wave network (with Security S2
Authenticated)
•
Red – device not added to a Z-Wave network
Update:
•
Blinking cyan – update in progress
•
Green
–
update
Authenticated)
•
Magenta
–
update
Authenticated)
•
Red – update not successful
Menu:
•
3 green blinks – entering the menu (added without Security S2
Authenticated)
•
3 magenta blinks – entering the menu (added with Security S2
Authenticated)
successful
(added
successful
(added
without
Security
with
Security
S2
S2
operatIng tHe DevIce
13