FIBARO RGBW CONTROLLER 2 Operating Manual page 24

24
confIguratIon
61.
This parameter determines the minimum change in consumed
power that will result in sending new power report to the main
For loads under 50W the parameter is not relevant and reports are
Power report are sent no often then every 30 seconds.
Parameter size 2B
Default value
Available
values
62.
This parameter determines in what time intervals the periodic
power reports are sent to the main controller. Periodic reports do
not depend of power change (parameter 61).
Parameter size 2B
Default value
Available
values
63.
This parameter defines minimal change (from the last reported) of
analog input value that results in sending new report.
Parameter is relevant only for analog inputs (parameter 20, 21, 22
Parameter size 1B
Default value
Available
values
64.
This parameter defines reporting period of analog inputs value.
Periodical reports are independent from changes in value (param-
Parameter is relevant only for analog inputs (parameter 20, 21, 22
Parameter size 2B
Default value
Available
values
Power reports - on change
controller.
sent every 5W change.
15 (15%)
0 - reports are disabled
1-500 (1-500%) - change in power
Power reports - periodic
3600 (1h)
0 - periodic reports are disabled
1-32400 (1-32400s) - report interval
Analog inputs reports - on change
or 23 set to 0 or 1).
5 (0.5V)
0 - reporting on change disabled
1-100 (0.1-10V, 0.1V step)
Analog inputs reports - periodic
eter 63).
or 23 set to 0 or 1).
0 (periodical reports disabled)
0 – periodical reports disabled
60-32400 (60s-9h, 1s step)