Table of Contents
Advertisement
12
6: Operating the device
6.1: Operating the device and colors
It is possible to control connected LED / RGB / RGBW strip with the
button located on the top of the device.
•
•
6.2: HomeKit status
After powering the device, the built-in LED light shows the current
device status:
•
•
6.3: Menu
Menu allows to perform basic device actions. In order to use the
menu:
1. Triple click and hold the button to enter the menu.
2. Release the button when device signals the desired position with
3. Quickly click the button to confirm.
6.4: Resetting to factory defaults
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about HomeKit and user configu-
ration will be deleted.
1. Triple click and hold the button to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to confirm.
4. After few seconds the device will be restarted, which is signalled
operatIng tHe DeVIce
1xclick – change to the opposite state (ON/OFF)
hold – start a gradual change of colour, releasing the button saves
the given value
GREEN – device added to HomeKit
RED – device not added to HomeKit
colour:
GREEN - reset energy consumption memory
•
•
YELLOW - reset to factory defaults
with the red colour.
Resetting the device will not reset the energy con-
i
sumption memory nor channels configuration. To re-
set energy consumption memory, see "Menu" subchapter.
Advertisement
Table of Contents
