Table of Contents
Advertisement
5.4.13 Adjusting the spindle bearing
Vertical spindle
Remove the top cover and unscrew drawbar, remove.
Loosen the stud screws on the bearing nut.
Slightly adjust the play in the bearing with the bearing nut.
Abb.5-11: Adjust vertical spindle bearing
Horizontal spindle
Remove the top cover.
Remove the transmission of the upper drive shaft.
Loosen the stud screws on the bearing nut.
Slightly adjust the play in the bearing with the bearing nut.
Bearing nut
Abb.5-12: Adjust horizontal spindle bearing
Version 1.0.4 - 2020-09-08
Draw bar
cover
Bearing nut
Translation of original instructions
MZ2S
EN
67
Advertisement
Table of Contents
