Connecting Wires To Terminals - Kenwood DPX502U Instruction Manual

Connecting Wires to Terminals

REMO.CONT
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
Power control/Motor antenna
control wire (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Steering remote control (Light Blue/Yellow)
To Kenwood disc changer/
External optional accessory
If no connections are made, do not
let the wire come out from the tab.
Battery wire (Yellow)
Ignition wire (Red)
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
To connect these leads, refer to the relevant
instruction manuals.
FM/AM antenna input (JASO)
Front left output (White)
Front right output (Red)
Rear left output /Sub Woofer left output (White)
Rear right output /Sub Woofer right output (Red)
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal
P.CONT
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
ANT.CONT
Antenna Cord
|
35
English