Garmin G1000 Pilot's Manual page 81

Figure 2-22 GPS CDI Setting on AUX – SYSTEM SETUP Page
When set to AUTO (default), the GPS CDI scale automatically adjusts to the desired limits based upon the
current phase of flight (see the following figure and table).
Departure
» Once a departure procedure is activated, the CDI is scaled for departure (0.3 nm).
» The system switches from departure to terminal CDI scaling (1.0 nm) under the following conditions:
ƒ The next leg in the departure procedure is not aligned with the departure runway.
ƒ The next leg in the departure procedure is not a CA, CD, CF, CI, CR, DF, FA, FC, FD, FM, IF, or TF (refer
to the Aviation Terms and Acronyms in the Appendices Section for leg type definitions).
ƒ After any leg in the departure procedure that is not a CA or FA.
190-02692-00 Rev. A
Enroute
Terminal
(Oceanic if >200 nm
from nearest airport)
Figure 2-23 Automatic CDI Scaling
Garmin G100 Pilot's Guide for the Piper PA-32 Saratoga
FLIGHT INSTRUMENTS
Refer to accompanying
approach CDI scaling figures
Terminal Approach
Missed
Approach
61