System Test - Garmin G1000 Pilot's Manual

SYSTEM TEST

NOTE: Traffic surveillance is not available during the system test. Use caution when performing a system
test while in-flight.
The traffic system provides a system test mode to verify the system is operating normally. The test takes about
ten seconds to complete. When the system test is initiated, a test pattern of traffic symbols is displayed on the
MAP - TRAFFIC MAP Page. The traffic system issues a voice alert when the test is completed. If the system
passes the test, the traffic system enters Standby Mode. If the system test fails, the system enters Failure Mode.
Testing the Traffic System:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the MAP - TRAFFIC MAP Page.
3) Turn the Joystick to set the range to 2/6 nm to allow for full traffic test pattern display.
4) Press the TEST Softkey.
Or :
1) Press the MENU Key and turn the small FMS knob to select 'Test Mode'.
2) Press the ENT Key.
190-02692-00 Rev. A
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga
HAZARD AVOIDANCE
353