Garmin G1000 Pilot's Manual page 262

FLIGHT MANAGEMENT
Procedure Loading Page
Selection Softkeys
Loading an approach into the active flight plan using the PROC Key:
1) Press the PROC Key. The PROCEDURES Window is displayed.
2) Highlight SELECT APPROACH, and press the ENT Key. The PROC – APPROACH LOADING Page is displayed.
3) Select the airport and approach:
a) Use the FMS Knob to select an airport and press the ENT Key.
b) Select an approach from the list and press the ENT Key.
Or :
a) If necessary, push the FMS Knob to exit the approach list, and use the large FMS Knob to move the cursor
to the CHANNEL Field.
b) Use the FMS Knob to enter the approach channel number, and press the ENT Key to accept the approach
channel number. The airport and approach are selected.
4) Select a transition (if required) and press the ENT Key.
5) Minimums
a) To set approach minimums, turn the small FMS Knob to select BARO or TEMP COMP and press the ENT
Key. Turn the small FMS Knob to select the altitude, and press the ENT Key.
b) If TEMP COMP was selected, the cursor moves to the temperature field. Turn the small FMS Knob to select
the temperature (as reported at the destination airport), and press the ENT Key.
Or :
To skip setting minimums, select OFF and press the ENT Key.
6) Press the ENT Key with LOAD? highlighted to load the approach procedure; or turn the large FMS Knob to
highlight ACTIVATE and press the ENT Key to load and activate the approach procedure.
When selecting a NAVAID exclusive approach, the popup message is displayed: 'NOT APPROVED FOR GPS –
GPS guidance is for monitoring only. Load approach?' With YES highlighted, press the ENT Key.
242
Selected Approach
Figure 5-80 Approach Loading
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga
Loaded Approach
190-02692-00 Rev. A