Installing The Card - Bosch Rexroth VT-VSPD Series Installation And Operation Manual

12/48 Bosch Rexroth AG | Hydraulics
2 Installing the VSPD
2.4

Installing the card

Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk
Only take the card from its packaging at a protected workplace.
Do not touch electrical components and install the controller card as shown in Fig. 2
Installing the controller card in the card holder provided for this purposes.
Installing the VSPD controller card correctly:
De-energize the rack used.
Hold the controller card by the front panel and take it out of the packing.
Slide the controller card into the guard rails of the rack as shown in Fig. "Installing
the controller card" without using excessive force.
Snap the edge connector in place by gently pressing on the front panel.
male connector
mounting
screws
Faceplate
Fig. 2 Installing the controller card
Tighten the two mounting screws on the front panel.
The controller card is now correctly installed.
www.hyquip.co.uk/web/index
Installation and operation | RE 30523-B/09.13
card
guide rails
HACD_HW_EN_2-2