Changing The Fuse - Bosch Rexroth VT-VSPD Series Installation And Operation Manual

RE 30523-B/09.13 | Installation and operation
6.2

Changing the fuse

Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk
The controller card is protected against overload by means of a fuse. The fuse is of a
disposable type and has the following data:
F / 4A / 250V
______________________________________________________________
NOTE!
The fuse is defective and must be replaced!
The fuse has opened due to mechanical damage or a product de-
fect.
In this case, replace the fuse with a new one of the type indicated
above.
The fuse has opened due to external influences, i.e. due to compo-
nents connected to the controller card.
In such cases, diagnose and correct the problem that caused the
fuse to open.
Only then replace the fuse with a new one.
______________________________________________________________
Replacing the fuse on the VSPD controller card:
Remove the VSPD controller card from the card holder. (reverse order as de-
scribed in chapter 2.4 Installing the card)
Remove the fuse from the fuse holder without excessive force (see Fig. 19 Fuse
on the VSPD controller card).
www.hyquip.co.uk/web/index
Hydraulics | Bosch Rexroth AG 43/48
Faults 6