Installing The Vspd; Safety Regulations - Bosch Rexroth VT-VSPD Series Installation And Operation Manual

8/48 Bosch Rexroth AG | Hydraulics

2 Installing the VSPD

2 Installing the VSPD
2.1

Safety regulations

Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk
Operate the VSPD controller card only when it is in technically perfect condition and in
accordance with the intended use, being aware of safety and risks and observing the
present documentation!
In the event of faults that affect safety or in the case of changes in the operating be-
havior, shut the controller card down immediately and inform the responsible person-
nel.
The proper and safe operation of the product implies proper transport, correct storage,
and installation as well as thorough commissioning and operation.
The VSPD controller card has been built using the latest technology, and in accord-
ance with recognized safety standards. Nevertheless, its use can result in personal
injury and damage to property, when:
You operate the VSPD controller card not in accordance with the intended pur-
pose (see page 9, Use in accordance with the intended purpose)
The VSPD controller card is not installed, commissioned and operated by special-
ist personnel.
You modify or convert the VSPD controller card improperly.
You do not observe the safety regulations and safety notes.
The VSPD controller card is intended for use in industrial applications.
The card must not be operated until it has been determined that the system in which
the controller card is installed, meets all applicable standards and safety regulations
for the application.
In European countries: EC Directive 89/392/EEC (Machinery Directive)
Operation is permitted only when applicable EMC regulations for the application are
met.
Adherence to limits defined by national regulations and standards is the responsibility
of the manufacturer of the system or machine.
In European countries: EC Directive 89/336/EEC (EMC Directive)
In the USA: National Electrical Code (NEC) and National Electrical Manufacturers
Association (NEMA), as well as local standards should be observed. The operator
must comply at any time with the points mentioned before.
www.hyquip.co.uk/web/index
Installation and operation | RE 30523-B/09.13