Nap Timer Function; Display Maximum / Minimum Temperature / Humidity - Auriol HG06061A-US Operation And Safety Notes

NAP timer function

Press and hold the NAP button
to set the duration of the nap timer. The currently set nap time
will flash on the time panel
Press the – / CH button
the maximum value (from 5 minutes up to a maximum of 2 hours
in 5-minute stages).
Press the NAP button
nap timer. The set time starts counting down. The alarm goes
off for around 2 minutes once the time has been counted down.
Press any button to deactivate the nap timer.
Display maximum / minimum
temperature / humidity
Once the power supply and the connection to the outdoor sensor
have been established, the maximum and minimum values for
temperature and humidity are automatically recorded and saved
by the weather station.
In basic mode, press the + / MEM button
symbol is shown next to the humidity display on both tempera-
ture panels, and the highest measured value for indoors and
outdoors is displayed.
In basic mode, if you press the + / MEM button
and outdoors is displayed.
After around 5 seconds, the current values for indoors and
outdoors will automatically be displayed.
26 US-EN
337765_1907_aur_Funk-Wetterstation_Content_US.indd 26
6
symbol is shown and the lowest measured value for indoors
button for around 3 seconds
6
.
5
or the + / MEM button
9
to confirm your entry and to start the
10
to set
10
once. The
twice the
10
13.01.20 10:19