Disassembly/Reassembly; Receivers/Transmitters; Power Amplifiers - Tait T880 II Series Adjustment Manual

Base station equipment

Table of Contents

M880-00

2.3

Disassembly/Reassembly

2.3.1

To carry out alignment or change option links, you need to remove only the top cover,

i.e. the one adjacent to the front panel handle and on the opposite side to the main

D-range connector (D-range 1/PL100).

You need to remove the bottom cover to:

• access the transmitter RF power module;

• change solder blob links;

• fit test leads to circuit block access points.

2.3.2

You should carry out the tuning and power output level setting procedures with the

cover on.

Note:

All black finish Pozidriv screws used in the T889 are 4-40 UNC thread and

cannot be interchanged with M3 screws. Note that different lengths are

used in different applications.

Mechanical

A2.3

10/07/00

Table of Contents

Table of Contents

T885 T881