5. Operation
5.1.
Basic Operation
⚫ Cyclic Display
In cyclic display, display and phases automatically change at every 5 seconds.
When
is pressed for about 2 seconds, the cyclic display appears.
DISPLAY
When
is pressed for about 2 seconds, the cyclic phase appears.
By pressing any other buttons except
Note 1: Before shifting to the cyclic display change screen, the display flickering 3 times.
Note 2: In the cyclic display, drawing number is not displayed.
Note 3: In the maximum value and the minimum value display, cyclic display is not available.
Example Cyclic Display (Phase wire System: 3-phase 4-wire, Display Pattern: P01,
Changes
automatically
(Displays for 5 seconds)
⚫ Harmonics display
Harmonic RMS value and distortion ratio can be displayed.
It is necessary to set the harmonics display settings before displaying.(Refer to page 22)
■Measurement items
Degree
RMS
value
Harmonic
○
total
⚫
Harmonics display (Continued from previous page)
■Switching phase (Phase wire System: 3-phase 4-wire)
Press
to switch phases.
PHASE
Harmonic current
Previous
display
Current total phase 1
Current total phase 2
DISPLAY
Current total phase 3
Note: For harmonic measurement, the following phases are not displayed.
Phase wire system
3-phase 3-wire
1-phase 3-wire
, cyclic display mode ends.
SET
Press for 2 seconds
(Displays for 5 seconds)
Changes automatically
N-phase
Harmonic
harmonic
current
current
Distortion
RMS
ratio
value
○
○
Harmonic current
(phase N)
PHASE
Current total phase N
DISPLAY
Harmonic current
3CT
2CT
2-phase
1N2 display
N-phase
1N3 display
N-phase
Changes
automatically
(Displays for 5 seconds)
Harmonic
voltage
Distortion
RMS
Distortion
ratio
value
ratio
―
○
○
Voltaget total phase 1N
Voltaget total phase 2N
DISPLAY
Harmonic voltage
―
31-phase
31-phase
12-phase
13-phase
40
without additional screens)
Changes
automatically
(Displays for 5 seconds)
■Example Display
Note : Harmonic total is shown by "ALL".
Harmonic voltage
Next
display
Voltaget total phase 3N
DISPLAY