Piston And Connecting Rod - Kubota EA330-E4 Series Workshop Manual

EA330-E4, WSM

(5) Piston and Connecting Rod

Connecting Rod Cap
1. Set the piston in the bottom dead center.
2. Remove the connecting rod screws (2) to remove the
connecting rod cap (1).
NOTE
• Untighten rod screws slowly and equally.
(When reassembling)
• Apply engine oil to the crank pin bearings and connecting rod
screws.
• The connecting rod cap must be installed with the stamped
mark facing the radiator so the mark (3) of the connecting rod
and that of the connecting rod cap are aligned.
IMPORTANT
• Screw the rod screws light by hand and fully insert it. If it
cannot be screwed in lightly by hand, clean the thread. If it
is still hard to screw, replace the screw.
Tightening torque Connecting rod screw
(1) Connecting Rod Cap
(2) Connecting Rod Screw
1-S35
ENGINE
(1) Piston
(2) Connecting Rod
(3) Crank PIn Bearing
(4) Connecting Rod Cap
(5) Connecting Rod Screw
(6) Crankcase Cover
(7) Piston RIng Assembly
(8) PIston Pin
(9) Piston Pin Bushing
9Y1211018ENS0051US0
27 to 30 N·m
2.7 to 3.1 kgf·m
20 to 22 lbf·ft
(3) Mark
9Y1211018ENS0052US0
KiSC issued 05, 2015 A