Kubota EA330-E4 Series Workshop Manual page 25

EA330-E4, WSM
Cleaning Fuel Element
CAUTION
• If the element is damaged, replace it. Otherwise, dust may
enter the injection pump and the nozzle, shortening their
service life.
1. Close the fuel valve.
2. Loosen the retainer ring (2) on the cap (3) and the bolt mounting
element holder, take out the cap, and clean out any dust or
water collected in the bottom of it.
3. The element (1) can be detached by pulling downward gently.
Immerse it in new fuel and swish gently to wash.
4. Apply a thin film of fuel to the O-ring and then fully tighten it by
hand.
IMPORTANT
• The retainer ring must be tightened by hand at all times.
(1) Filter Element
(2) Retainer Ring
G-9
GENERAL
(3) Filter Cap
9Y1211018GEG0010US0
KiSC issued 05, 2015 A