Starter - Kubota EA330-E4 Series Workshop Manual

EA330-E4, WSM

(7) Starter

Magnet Switch
1. Disconnect the connecting lead.
2. Remove the mounting nut.
3. Remove the magnet switch (1) by sliding it up so that it is
disconnected from the drive lever.
(1) Magnet Switch
Armature Brake
1. Remove the end frame cap (1).
2. Remove the brake shoe (2).
3. Remove the brake spring (3).
4. Remove the gasket (4).
(When reassembling)
• After reassembling the brake shoe (2), adjust the shaft thrust
gap.
(1) End Frame Cap
(2) Brake Shoe
End Frame
1. Remove the two through bolts.
2. Remove the end frame (1).
(1) End Frame
Brush Holder
1. Draw out the brush from the holder while holding the spring up.
2. Remove the brush holder (1).
(When reassembling)
• When replacing the spring, install it by referring to the figure.
• Do not contact the brush's positive lead with the body.
(1) Brush Holder
(2) Spring Hanger
1-S42
ENGINE
9Y1211018ENS0064US0
(3) Brake Spring
(4) Gasket
9Y1211018ENS0065US0
9Y1211018ENS0066US0
(3) Attach the brush spring in this
method
(4) Brush
9Y1211018ENS0067US0
KiSC issued 05, 2015 A