Kubota EA330-E4 Series Workshop Manual page 89

EA330-E4, WSM
Fuel Tank and Filter
1. Close the fuel valve (7) as shown in the photograph.
2. Remove the engine hook (1) and radiator cover (2).
3. Disconnect the overflow hose (3).
4. Remove the eye joint bolt of the injection pump to detach the
fuel hose 2 (4).
5. Remove the fuel filter mounting screw (8).
6. Remove the fuel tank (5), fuel filter and hose as an unit.
7. Remove the radiator net (6).
(When reassembling)
• Lap the overflow hose (3) below the radiator cover (2) as shown
in the photograph.
• Set the hose clamps securely.
Injection pump eye joint
Tightening torque
bolt
(1) Engine Hook
(2) Radiator Cover
(3) Overflow Hose
(4) Fuel Hose 2
Wire Harness
1. Disconnect the fan leads (1).
(When reassembling)
• The lead wire must be grounded at particular locations as
illustrated.
Tightening torque Glow plug terminal nut
(1) Fan Lead
Fan Cover and Starter
1. Disconnect the glow plug cord (4).
2. Remove the flywheel cover (2).
3. Remove the fan cover (3).
4. Remove the starter (1), wire harness and battery cable as an
unit.
(1) Starter
(2) Flywheel Cover
Cooling Fan
1. Remove the tension pulley (2).
2. Remove the cooling fan assembly (1).
(When reassembling)
• Adjust the fan belt tension to the factory specifications.
(1) Cooling Fan Assembly
1-S24
ENGINE
25 to 29 N·m
2.5 to 3.0 kgf·m
18 to 21 lbf·ft
(5) Fuel Tank
(6) Radiator Net
(7) Fuel Valve
(8) Fuel Filter Mounting Screw
9Y1211018ENS0026US0
0.98 to 1.7 N·m
0.10 to 0.18 kgf·m
0.73 to 1.3 lbf·ft
9Y1211018ENS0027US0
(3) Fan Cover
(4) Glow Plug Cord
9Y1211018ENS0028US0
(2) Tension Pulley
9Y1211018ENS0029US0
KiSC issued 05, 2015 A