Printronix ProLine 5 Series Manual page 25

3. Locate the notch in the lower left corner of the back of the cabinet (See
Figure 2–1).
4. Hold the I/O cable below its connector and gently push the cable through the
opening in the grommet seated in the notch (See
5. Pull the cable up through the notch until it reaches the I/O plate. Attach the
cable connector to the printer interface connector previously selected in step
2 of this section. Secure the cable to the printer using the upper and lower
standoffs (See Figure
6. Open the cabinet front door and cut the strap that secures the box, which
contains the power cord, printer ribbon, control panel overlay labels, and
documentation.
7. Open the box and remove the power cord, overlays, and documentation.
8. Guide the power cord up through the hole in the lower right back corner of
the cabinet. Thread the power cord inside the bracket where the gas spring is
attached (See Figure
9. Plug the power cord into the printer AC power connector, then into the AC
power outlet (See
2–14
2–1).
2–1).
Figure 2–1).
Figure 2–1).
Box
Strap
Setting Up the Printer