Elephant Robotics Catbot Series User Manual page 10

up) and wear a work cap, not wearing a variety of jewelry.
Operators who work with the robot must be familiar with the content and
exact location of the various warning signs and symbols on the device and
ensure their integrity and clarity. Before turning the device on and off,
4 make sure that all safety devices and related accessories are working
properly and that no one is in a dangerous location where the device is
activated. When the robot runs abnormally, it should stop immediately and
report in time.
The operator must clarify the scope of responsibility for operation,
commissioning, maintenance and repair. The operator is not allowed to
5
change the operating procedures and teaching at will. No other personnel
may enter the collaborative operation space and the danger zone.
During maintenance work, the warning sign must be hung to enter the
6
collaborative operation space.
When the operator is in production, it should be ensured that each starting
7
device is normal and is not allowed to start at will.
When the maintenance and operation personnel perform maintenance on
8 the equipment, the main power switch must be turned off before
maintenance work can be performed.
No objects should be stacked in the robot working area, and no debris
9
should be stacked in the control box.
After the operation is completed, the gas and electricity switches should
10 be closed according to the process, and the work site should be cleaned
up.
It is forbidden to shake the robot hard and hang heavy objects on the
11
robot.
12 All dangerous behaviors or games are prohibited around the robot.
After installing the robot, make sure the robot is fixed on a stable surface
13
for subsequent operations.
It is important to ensure that the robot does not collide with itself or other
14
objects during exercise.
If the robot is damaged, do not continue to use it and contact the relevant
15
personnel for processing.
Please use the robot within the robot's parameter range and service life,
16
otherwise it may cause serious safety problems.
After the emergency stop state is cancelled, the servo power must be
17
turned on before the servo power supply is turned on again.
Please pay attention to the rotating shaft of the robot to prevent the cable
18 and the air tube from being entangled. Keep a distance from the moving
shaft to prevent hair or clothings from getting entangled.
Shenzhen Elephant Robotics Technology Co., Ltd.
7