KYOWA WGA-910A Series Instruction Manual page 26

9. LIST OF COMMANDS
All commands are applicable to the [Command processing request 2] / [Command processing response 2].
9-1. COMMANDS FOR THE MEASUREING CONDITION (OPERATION PATTERN)
Function
Comparison [HH]_Comparator
Setting
[HI]_Comparator
[LO]_Comparator
[LL]_Comparator
Using Comparator
[HH]_Comparator
Using Comparator
[HI]_Comparator
Using Comparator
[LO]_Comparator
Using Comparator
[LL]_Comparator
Comparator Output
Logic
Hysteresis Width
Measure Mode Operation Mode
Setting
Display Mode
Comparison Mode
Delay Time
Detect Time
Command
Item
0 5 1 1 -99999 to +99999
0 5 2 1 -99999 to +99999
0 5 3 1 -99999 to +99999
0 5 4 1 -99999 to +99999
0 4 1 1 0: Use, 1: Not use
0 4 1 2 0: Use, 1: Not use
0 4 1 3 0: Use, 1: Not use
0 4 1 4 0: Use, 1: Not use
0 4 1 5 0: Negative Logic,
0 4 1 6 0 to 9999
0 7 0 1 0: Normal,
0 7 0 2 0: Normal Disp.
0 7 0 3 0: Normal Comp.
0 7 0 4 0.00 to 9.99 sec.
0 7 0 5 0.00 to 9.99 sec.
1: Positive Logic
1: Peak Hold,
2: Block Peak,
3: Time Peak,
4: Bottom Hold
5: Block Bottom,
6:Time Bottom,
7: Arbitrary Hold,
8:Block Peak-Bottom,
9:Time Peak-Bottom,
10:Block Average,
11:Time Average
1: Hold Disp.
1: Hold Comp.
24
Pre-set value