KYOWA WGA-910A Series Instruction Manual page 10

The applicable connector of the CC-Link cables is as follows. (Optional accessories)
Name
Wire mount socket
Branch connector (type-Y)
Termination connector
NOTE
To locate the products at both ends of the CC-Link network, be sure to mount the termination
connectors.
The branch connector (type-Y) requires the wire mount socket.
Connect cables as follows.
1) Strip the coating of the wire for approx. 30 to 35 mm.
Twist the wires together tightly.
The available wires are as follows.
Conductor size:
Insulated jacket O.D.:
2) Insert the wires into the drain hole on the connector cover.
Push the connector cover into the body.
5. STATUS LED
Indicate the communication status as follows.
LED name
RUN Working properly
SD Sending...
RD Receiving...
ERR CRC error
Model
35505-6000-BOM-GF
35715-L010-B00 AK
35T05-6M00-BOM GF
2
0.5 mm
φ2.2 to φ3.0 mm
ON
Resetting..., communication error
Working properly
Manufacture
3M Japan Limited
3M Japan Limited
3M Japan Limited
(AWG20)
OFF
―――
―――
8
Flickering
―――
―――
―――
―――