Table of Contents
Advertisement
Mounting and dismantling
4.4 Installing, mounting and removing the 3RW5 HMI
Procedure with door mounting kit IP65
Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI High Feature
Ensure that the seal does not overlap.
Place the 3RW5 HMI High Feature in the cutout of the control cabinet door
Continue to screw the screws into the fixing brackets
at the front. Fasten the fixing brackets onto the 3RW5 HMI High Feature
Tighten the 3RW5 HMI High Feature with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
68
.
until they protrude approx. 8 mm
Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
.
.
.
SIRIUS 3RW52 Soft Starter
Advertisement
Table of Contents
