Table of Contents
Advertisement
Description
3.11 Accessories
3RW5 HMI High Feature (HF)
The 3RW5 HMI High Feature can be used to parameterize, monitor and control
(motor ON / OFF) the 3RW52 soft starter. The 3RW5 HMI High Feature can be installed in
the 3RW52 soft starter or in the control cabinet door or mounted on a wall using accessories.
It can be connected to the SIRIUS Soft Starter ES software (TIA Portal) via the local
interface. The 3RW5 HMI High Feature has a TFT color display, LEDs for the status display,
and function and control keys.
Functions
Language selection
Starting and stopping the motor via control keys
Local interface
Display of error diagnoses as plain-text messages
Display of up to 5 measured values at the same time
Analog output and ON / RUN relay output can be parameterized with the
3RW5 HMI High Feature.
Setting communication parameters of 3RW5 communication modules:
– PROFINET (device name and the IP parameters)
– PROFIBUS (station address)
– Modbus TCP (IP parameters)
– Modbus RTU (station address)
– EtherNet/IP (IP parameters)
Backup of parameterization data on a micro SD card
The display of the device LEDs of the 3RW5 HMI High Feature shows the messages of
the following devices:
– 3RW52 soft starter
– 3RW5 HMI High Feature
– Communication module (if there is one)
Firmware updates can be performed using the 3RW5 HMI High Feature and a
micro SD card for the following devices:
– 3RW52 soft starter
Note the information in chapter Firmware update (Page 22).
52
– 3RW5 HMI High Feature
– Communication module (if there is one)
Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
SIRIUS 3RW52 Soft Starter
Advertisement
Table of Contents
