CODELOCKS KitLock KL1100 Manual page 6

General Low battery
Remote Codelocks
Card Card
Authorisation Manager
Client
installation
When the battery power is low the Red LED will flash three times before
the Blue LED flashes to signal acceptance of the smart card. Batteries
should be changed as soon as this happens.
The lock will operate for approximately 100 times with low battery.
On a no-power event, power may be supplied via the USB connector on
the front-plate. Use the Master User Card to open the lock and change
the batteries.
To use RCA, you must meet the following prerequisites:
• Have a Codelocks Portal account (free to sign-up)
Have purchased the Codelocks Keypad Accessory Unit
•
Set-up:
1. Sign into Portal - navigate to Remote Card Authorisation >
Register & Install Card Manager Client
2. Enter a name for the particular Card Manager Client. E.g. if the
software and USB card reader are being installed in reception,
you could enter "Reception"
3. Click "Save"
4. Once the information has been saved, follow the on-screen
instructions. Do not leave the page or close your browser
window until you have followed the installation instructions:
1. Download and install the Codelocks Card Manager
Client software
2. During installation, you will be asked for the security
certificate - copy this from the on-screen instructions and
paste it into the box provided
5. Once installation is complete, a confirmation message will be
displayed