CODELOCKS KitLock KL1100 Manual page 5

Open at set
time
Dual
authorisation
User Add/Remove
Management User Card
(Local)
(Private Use)
Removing all
User Cards
(Local)
(Private Use)
Note: The Codelocks Keypad Accessory Unit is required for this function
Note: Date/time must be set for this function
1. Plug the Codelocks Keypad Accessory Unit into the lock
2. Touch the Master User Card to the lock
3. On the keypad, enter:
1. Press # • 11 • <Hour at which to unlock - hh format> ••
Note: Where any two Card Clients are required to open the lock (either a
standalone, User Card (local), or a Remotely Authorised Card.
1. Plug the Codelocks Keypad Accessory Unit into the lock
2. Touch the Master User Card to the lock
3. On the keypad, enter:
1. Press # • 12 • <0 to disable|1 to enable> ••
1. Touch the Master User Card to the front of the lock
2. Touch a User Card to the front of the lock
1. If the User Card is not already registered, it will be added
2. If the User Card is already registered, it will be removed
3. Repeat step 2 within 5 seconds to continue adding/removing
User Cards
4. Once complete, wait 5 seconds and the lock will return to normal
operation
Note: Presenting the Master User Card to the lock will cause the lock to
unlock.
Perform factory reset
or with the optional Codelocks Keypad Accessory Unit:
1. Plug the Codelocks Keypad Accessory Unit into the lock
2. Touch Master User Card to lock
3. On the keypad, enter:
1. Public Use: press # • 08 • 08 ••