1. Manuals
  2. Brands
  3. CODELOCKS Manuals
  4. Locks
  5. KL1000 NetCode
  6. Getting started

CODELOCKS KL1000 NetCode Getting Started

Hide thumbs
1
2
3

Advertisement

Table of Contents

Codelocks Support
KL1000 NetCode - Getting Started Installation
Instructions and Quick Start Guide
The KL1000 NetCode supports date/time sensitive NetCodes which can be generated via the NetCode Portal. 
You must have access to a browser with internet access to set-up NetCode.
 

Special Notes

Please read carefully:
Before installing the lock, load the batteries and familiarise yourself with the operation and programming.
The handle will not turn until you enter the factory default Master Code 11335577 or the User Code 2244.
Visit www.codelocksportal.net to proceed with the set-up. Note that you will need to register for an account
if you do not already have one.
Once signed-in, choose Add Lock. As part of the initialisation process, you will be given a program string
to enter into your lock. When displayed, this should be entered immediately.
Your KitLock is supplied ready to fit to doors up to 19mm (3⁄4") thick. For doors between 19mm (3⁄4") and
25mm (1") thick, you will need to install the 28.5mm (1 1⁄8") spare spindle (see below). A 12mm (1⁄2")
spindle is also included for sheet metal doors.
https://codelocks.zohodesk.eu/portal/en/kb/articles/kl1060-getting-started-installation-instructions-and-quick-start-guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KL1000 NetCode and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for CODELOCKS KL1000 NetCode

Summary of Contents for CODELOCKS KL1000 NetCode

  • Page 1 Codelocks Support KL1000 NetCode - Getting Started Installation Instructions and Quick Start Guide The KL1000 NetCode supports date/time sensitive NetCodes which can be generated via the NetCode Portal.  You must have access to a browser with internet access to set-up NetCode.  ...
  • Page 2   Public & Private Functions Although the KL1000 NetCode is intended as a NetCode lock, the KL1000 NetCode does support traditional Public & Private Functions. Documentation for these functions can be found at www.support.codelocks.com   Factory Reset You may need to reset your lock to factory settings if you want to re-register the lock on the NetCode Portal or have forgotten the Master Code.
  • Page 3   A. Replace existing cam lock with KL1000 NetCode 1. Remove existing cam lock. 2. Place the 16mm (5⁄8") template hole over the hole left by the cam lock and mark the upper fixing hole. 3. Drill the 6mm (1⁄4") fixing hole.

Table of Contents