Toro Reelmaster 335-D Service Manual page 93

Hydraulic Tester - With Pressure and Flow Capabilities
You must have o-ring face seal (ORFS) adapter fittings
for this tester to use it on the Reelmaster 335-D.
1. INLET HOSE: Hose connected from the system
circuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 - 1000 PSI.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
®
Reelmaster 335-D
Low Pressure
Gauge
Gauge
Protector Valve
Inl et Hose
Figure 8
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the
hydraulic tester to be connected to the hydraulic system
circuit.
Page 4 - 13
Load Valve
Flow Meter
High Pressure
Gauge
Outlet
Hose
Special Tools