Toro Reelmaster 335-D Service Manual page 16

REELMASTER® 335-D and 3500-D Maintenance Schedule
Minimum Recommended Maintenance Intervals:
Maintenance Procedure
Inspect Air Filter, Dust Cup, and Baffle
Lubricate All Grease Fittings
‡ Change Engine Oil & Filter
Check Battery Level and Connections
Inspect Cooling System Hoses
Service Air Cleaner Filter Element
Inspect Cutting Unit Reel Drive Belts
† Torque Wheel Lug Nuts
Replace Fuel Filter
Check Front Transaxle Oil level
Check Rear Axle Oil level (4WD)
Inspect Fuel Lines and Connections
‡ Check Engine RPM (idle and full throttle)
Inspect Engine Fan Belt
Inspect Engine Timing Belt
Drain and Clean Fuel Tank
Change Hydraulic Oil
‡ Replace Hydraulic Oil Filter
Change Front Transaxle Oil
Pack Rear Axle Bearings (2WD)
Change Rear Axle Oil (4WD)
Check Rear Wheel Toe-in
† Initial break in at 10 hours
‡ Initial break in at 50 hours
Replace Moving Hydraulic Hoses
Replace Safety Switches
Cooling System - Flush/Replace Fluid
See Operator's and Service Manual for specifications and procedures)
NOTE: Replace Timing Belt if worn, cracked or oil soaked. A new Timing Belt should be installed
any time the Belt is removed or loosened.
Maintenance Interval & Service Type
Every
50hrs
A Level
Service
(see note below)
Items listed are recommended every 1500 hours
Every
Every
200hrs
100hrs
B Level
Service
C Level
Service
Annual Recommendations:
or 2 years whichever occurs first.
:
Every
Every
800hrs
400hrs
D Level
Service
E Level
Service