Toro Reelmaster 335-D Service Manual page 230

Adjusting Pinion Shaft Cone Center
"Cone Center" is the distance from the mating face of
axle housing to end face of pinion (Fig. 25A). This
distance can be increased or decreased by installing
removing shims.
Cone center specification
Shim stock for this adjustment is available in the follow ­
ing thicknesses:
Thickness
Shim set
0.1 mm (0.004 in.)
0.2 mm (0.008 in.)
0.4 mm (0.016 in.)
Determine the required thickness of shim by proceeding
as follows:
1. Apply grease to o-rings. Install o-rings to sleeve, then
install sleeve assembly into adapter case.
2. Put a straightedge on end of pinion shaft and measure
distance between bottom of straightedge and face of
adaptor case (Fig. 25B). Subract 43 mm (1.69 in.) from
measured distance. Select shim(s) closest to result.
Example: 43.18 mm (measured distance) – 43 = 0.18 mm.
Use 0.02 mm shim.
Apply grease to o-ring and fit to mating face of sleeve.
Attach adapter case to axle housing (A) and secure by
tightening bolts to proper torque.
Adapter bolt torque
Repairs
43 ± 0.05mm
(1.69 ± 0.002 in.)
Part No.
77-4010
76-7410
76-7420
77-7430
2.5 ∼ 3.0 kg-m
(18 ∼ 22 ft-lb)
Page 6 - 16
Figure 25A
Figure 25B
Reelmaster
®
335-D