Toro Reelmaster 335-D Service Manual page 250

4. Disassemble the cone nut from the shoulder bolt
securing the bearing housing to the side plate, remove
the belleville washer and bolt and slide the bearing
housing off the reel shaft (Fig. 21).
5. Disassemble the cover from the drive housing and
remove the drive belt from the housing (Fig. 22).
6. Remove the reel capscrew, toothed washer and
pulley washer from the reel shaft (Fig. 22). (Note: Cap­
screw is assembled with a thread locking compound).
7. Using a puller,remove the driven pulley from the reel
shaft (Fig. 22). Remove the woodruff key from the reel
shaft.
8. Remove the adjustment assembly and cone nut,
belleville washer and shoulder bolt securing the housing
to the side plate (Fig. 22). Remove the housing.
9. Slide the reel assembly out of the slots in the side
plates.
10. To remove the bearing and seals from the drive
housing, remove the retaining ring from inside the hous­
ing. Pry the outer seal out of the belt drive case side.
Press the bearing and rear seal out from the outer side
of the housing.
11. To remove the bearing and seal from the bearing
housing, remove the dust cap (Fig. 19) and press the
bearing and seal out of the housing.
Repairs
1. Reel capscrew
2. Pulley washer
3. Driven pulley
4. Drive housing
Page 7 - 14
Figure 21
1. Drive housing (cover removed)
2. Drive belt
Figure 22
5. Adjustment handle assembly
6. Woodruff key
7. Drive housing fasteners
Reelmaster
®
335-D