General Run and Transport Problems (continued)
Condition
___________________________________________________________________________________________
4WD does not engage.
________________________________________________________________________________________________________________________________________________________
Battery does not charge.
®
Reelmaster
335-D
Possible Cause
Axle in Hi range.
Axle HI/Low switch faulty.
Axle Hi/Low switch wiring loose,
corroded or damaged.
4WD solenoid valve faulty.
4WD solenoid wiring loose, cor-
roded or damaged.
Problem is not electrical.
Loose or broken wire(s).
Faulty alternator.
Dead battery.
Page 5 - 11
Correction
Axle must be in Low range for
4WD to engage.
Test HI/Low switch. Replace
switch if faulty. Make sure switch
is screwed all the way in.
Repair wiring.
Test 4WD solenoid valve. Re
place if faulty.
Repair wiring.
See Troubleshooting section of
Chapter 4 - Hydraulic System.
Repair wiring.
Check alternator belt tension.
Test alternator and replace if
faulty.
Charge battery. Replace battery if
it will not hold a charge.
Troubleshooting