Alternate Mounting-Wallboard Mounting; Install Versicharge; Figure 2. Alternate Installation Of Versicharge Mounting; Figure 3. Slide Versicharge Onto Mounting Hinges - Siemens VersiCharge AC 8EM1312-4AF10-0AA3 Installation And Operation Manual

VersiCharge™ AC | Installation and Operations Manual
2.3 Alternate mounting − Wallboard mounting
(Use mounting holes on 4 corners)

Figure 2. Alternate installation of VersiCharge mounting

NOTE: For installation, the mounting-bracket hinges
will be pointing to the ceiling, and the flat side of
the bracket will be against the wall.
NOTE: The VersiCharge can be mounted using
5 #12 x 1-½ LG Phillips head 0.375 head minimum
with 5 #10 wall anchors
NOTE: Recommended - The 5 anchors must be at
least 61lb. anchors rated for 1/2" dry wall.
(SCREWS AND ANCHORS NOT INCLUDED IN KIT.)
1. Locate the mounting bracket not more than 12" above a
240 V outlet or if hardwiring, the wiring will come through
the bottom of the charger.
2. Level the mounting bracket and drill 4 holes, one in each
corner of the bracket.
3. Place anchors into the wallboard until they are flush with
the wall.
4. Place the mounting bracket over the holes (hinges facing
upward, flat side of the bracket against the wall) with the
anchors and screw the mounting to the wall securely.
5. Add a 5th hole for mounting the holster once the unit is
mounted on the wall. Place the holster on the wall and
mark the correct position for the hole. Refer to Section 2.5
and its graphic.
10

2.4 Install VersiCharge

Figure 3. Slide VersiCharge onto mounting hinges

NOTE: For installation, the mounting-bracket hinges will
be pointing to the ceiling, and the flat side of the bracket
will be against the wall.
1. If hardwiring the unit, see Hardwire Installation.
2. Slide the VersiCharge on to the hinges.
3. Rotate to the right until the unit clicks and is closed.
4. Secure the enclosure with the locking mechanism after
installing the holster and plug the VersiCharge into the 240 V
outlet.