Rfid Setup - Siemens VersiCharge AC 8EM1312-4AF10-0AA3 Installation And Operation Manual

4: RFID Setup

RFID Cards Supported by VersiCharge
Cards Family Memory
MIFARE Classic 1K, 4K
MIFARE Plus 1K, 2K,4K
MIFARE DESFire 2K, 4K, 8K
MIFARE Ultralight 40,48,128,144
RFID functionality is an available feature for part numbers
8EM1310-4CF14-0GA0, 8EM1310-5CF14-0GA0, 8EM1310-4CF14-
1GA1, and 8EM1310-5CF14-1GA1. Pass the RFID card in front of
the RFID and, if successful, the Charging Process Light will flash
twice from the bottom up, there will be an audible tone
increasing to one second long. If the card swipe is not
successful, the Charging Process Lights will flash for one
second, decreasing to .25 seconds; this will happen two times.
There will be an audible tone, decreasing if card swipe is
unsuccessful.
RFID State Description
RFID Swipe Successful Charging LED ON/Blinking. White #2, #4, #6 &
#8 every 1/4 second in incremental pattern
starting from 0.25S, 0.5S,0.75S and 1S. Repeat 2
times. Audible single beep tone.
RFID Swipe not successful Charging LED OFF. White #2, #4, #6 & #8 one
Second in decremented pattern starting from
1S, 0.75S,0.5S and
Audible dual beep tone.
RFID card management can be performed via the ModBus
controller, OCPP-based server, or manually using Admin cards
provided with the unit - (Note: Admin cards may not be used
when the unit is connected to an OCPP server). For more
information on how RFID is implemented in the OCPP protocol--
see the OCPP Implementation Guide for VersiCharge AC Series
of Chargers at usa.siemens.com/versicharge. Please refer to
ModBus map to implement the appropriate commands to add/
remove or authorize charging sessions. VersiCharge maintains a
local preauthorized list which holds the list of all authorized
user cards. An authorized user card in the preauthorized list,
when tapped, will allow the charging session to start.
To add user cards to pre-approved, tap Admin card, followed by
tapping user card(s) that are to be added to the preauthorized
list. Once all user cards are added, tap the Admin card to finish
the operation of adding user cards to local preauthorized list. In
order to remove a user card from pre-approved, tap the Admin
card followed by the user card already in the preauthorized list,
then tap Admin card again to end the removal process.
Security Protocol Support
Crypto1 ISO14443A Part 1-3
AES, Crypto1 ISO14443A Part 1-4
AES, 3DES ISO14443A Part 1-4
None, 3DES ISO14443A Part 1-3
0.25 S. Repeat 2 times.
Installation and Operations Manual
Admin Card
User Card
| VersiCharge™ AC
21