Installing The G1330B Thermostat - Agilent Technologies 1200 Series User Manual

3

Installing the G1330B Thermostat

Installing the G1330B Thermostat

Installing the G1330B Thermostat
Instrument is partially energized when switched off
WA R N I N G
The power supply still uses some power, even if the power switch on the front panel
is turned off.
➔
Personal injury
WA R N I N G
To avoid personal injury, keep fingers away from the needle area during autosampler
operation.
➔
➔
"Defective on arrival" problems
C A U T I O N
If there are signs of damage, please do not attempt to install the module. Inspection by
Agilent is required to evaluate if the instrument is in good condition or damaged.
➔
➔
24
To disconnect the ALS thermostat from line, unplug the power cord.
Do not bend the safety flap away from its position, or attempt to remove the safety
cover (see Figure 6 on page 25).
Do not attempt to insert or remove a vial from the gripper when the gripper is
positioned below the needle.
Notify your Agilent sales and service office about the damage.
An Agilent service representative will inspect the instrument at your site and
initiate appropriate actions.
1200 Series AT User Manual