Agilent Technologies 1200 Series User Manual page 40

3
Installing the G1330B Thermostat
Installing the G1330B Thermostat
5 If you decide to update to A.04.02, insert the A.04.02 CD-ROM and select
6 After you have updated your system, insert the 3.5 inch floppy labeled
Starting from revision A.05.01 of the Agilent ChemStation
If you already have the Agilent ChemStation A.05.01 installed, you only need
to install the update to A.05.02 Beta. This update comprises only the driver for
the thermostatted autosampler, no other changes are made.
1 Insert the 3.5" floppy labeled Driver update Disk (A.05.02 Beta).
2 Open a DOS prompt by selecting Start->RUN and typing command.
3 At the DOS prompt type A:.
4 Press Enter and then HPUPDATE.
5 Press Enter only if your Agilent ChemStation is installed in the directory
40
Press Enter only if your Agilent ChemStation is installed in the directory
C:\HPCHEM. If your Agilent ChemStation is installed in a different
directory, e.g. D:\HPCHEM, you need to type HPUPDATE D:\HPCHEM and
press Enter.
SETUP on the CD-ROM using File Manager or Explorer. Select Yes to
continue with the update.
Driver update Disk (A.04.03) and open a DOS prompt by selecting
Start->RUN and typing command. At the DOS prompt type A: and press
Enter and then HPUPDATE.
Press Enter only if your Agilent ChemStation is installed in the directory
C:\HPCHEM. If your Agilent ChemStation is installed in a different
directory, e.g. D:\HPCHEM, you need to type HPUPDATE D:\HPCHEM and
press Enter.
C:\HPCHEM.
If your Agilent ChemStation is installed in a different directory, e.g. D:\
HPCHEM, you need to type HPUPDATE D:\HPCHEM and press Enter.
1200 Series AT User Manual