Agilent Technologies 1200 Series User Manual page 28

3
Installing the G1330B Thermostat
Installing the G1330B Thermostat
4 Connect the condensation leak tube to the main waste exit of the
5 Install the front cover of the autosampler thermostat.
6 Place the autosampler module on top of the autosampler thermostat. Make
7 Place the air channel adapter into the autosampler tray base. Make sure the
28
autosampler thermostat and place into an appropriate vessel. It is possible
to either let the condensation leak tubing exit the module at the front or at
the left side of the module. Make sure that the leak tube is fully fixed on the
outlet.
Figure 8 Condensation Leak outlet
sure that the autosampler is correctly engaged in the autosampler
thermostat locks.
adapter is fully pressed down. This assures that the cold airstream from the
autosampler thermostat is correctly guided to the tray area of the
autosampler.
1200 Series AT User Manual