Table of Contents
Advertisement
Processor mode?
Note
Modify value for
Stack Pointer (SP)?
4-8 Configuring the Emulator
This configuration defines operation mode of the processor.
single
The emulator will operate in single-chip mode.
expand8
The emulator will operate in memory expansion
mode with 8 bit data width.
expand16
The emulator will operate in memory expansion
mode with 16 bit data width.
proc8
The emulator will operate in microprocessor mode
with 8 bit data width.
proc16
The emulator will operate in microprocessor mode
with 16 bit data width.
You may need to set up a switch inside the emulation pod in addition to
this configuration. Refer to the manual provided with your emulation
pod.
Reset value for the stack pointer is automatically set up to the end of
internal RAM area. When the processor you select has no internal
RAM, it is set up to FFF hex. If you would like to change the value,
answer "yes" to this question.
Reset value for Stack Pointer (SP)?
This question allows you to specify the value to which the stack pointer
(SP) will be set on entrance to the emulation monitor initiated RESET
state. The address specified in response to this question must be a
16-bit hexadecimal address.
This address should be defined in RAM area (internal RAM, target
RAM or emulation RAM) which is not used by user program. When
the emulator breaks to the background monitor, the background
monitor uses 5 bytes of stack area.
Advertisement
Table of Contents
