Running the
Program
From Transfer
Address
Note
From Reset
The "run" command lets you execute a program in memory. Entering
the "run" command by itself causes the emulator to begin executing at
the current program counter address. The "run from" command allows
you to specify an address at which execution is to start.
The "run from transfer_address" command specifies that the emulator
start executing at a previously defined
"start address".
run from transfer_address <RETURN>
The run from transfer_address command is not available when you
use MELPS 7700 Hex format.
The "run from reset" command specifies that the emulator begin
executing from reset vector as actual microprocessor does.
(See "Running the Emulation from Target Reset" section in the
"In-Circuit Emulation" chapter).
Getting Started 2-17