Emulator
Reconfiguration
Processor type?
Note
Note
4-6 Configuring the Emulator
The emulator reconfiguration questions allows you to reconfigure the
emulator for your system. Type of the processor, processor operation
mode and reset value for the stack pointer will be configured here. To
access the emulator reconfiguration questions, you must answer "yes"
to the following question.
Reconfigure emulator?
This configuration item allows you to select the processor you are
going to emulate.
Processors supported by the 7750/51 emulator are listed in the
Processor Support List for HP MELPS Emulators. This list describes
appropriate <chip_name> which is needed for this configuration item.
Refer to this list to know appropriate <chip_name>, or to determine if
your processor is supported or not.
If you enter incorrect <chip_name> for this item, processor type is not
changed and this configuration will be finished. Then, you need to
RECALL this configuration item and re-enter correct <chip_name>.
If your processor is not included in the Processor Support List for HP
MELPS Emulators. You need to select "other" in this item and answer
to the following questions.
Usually, the previous question set up internal memory addresses
automatically. However, when your processor is not supported by the
previous question, you must configure the following questions by
yourself.