Monitor Type - HP 7750 Series User Manual

Note

Monitor type?

4-10 Configuring the Emulator
yes Enables the high speed access mode of the
emulator. In the high speed access mode:
The emulator can run with no wait state up to 25 MHz.
you can map the emulation memory only to the
following address ranges.
Memory Monitor
128K Background
128K Foreground
512K Background
512K Foreground
1M Background
1M Foreground
2M Background
2M Foreground
no Select the normal mode. In the normal mode:
You can define up to 16 different map terms which
can be placed wherever you like. (Refer to "Mapping
memory" section in this chapter.)
The emulator generates the /RDY signal, and inserts
one wait state for all memory access.
Changing this configuration will reset the memory map,
The monitor type configuration question allows you to choose between
a foreground monitor (which is supplied with the emulation software
but must be assembled, linked, converted, and loaded into emulation
memory) or the background monitor (which resides in the emulator).
The emulation monitor is a program that is executed by the emulation
processor. It allows the emulation system controller to access target
system resources. For example, when you enter a command that
requires access to target system resources, say a command to display
Available location
000000H-01F7FFH
000000H-01FFFFH
000000H-07F7FFH
000000H-07FFFFH
000000H-0FF7FFH
000000H-0FFFFFH
000000H-1FF7FFH
000000H-1FFFFFH