Running the
Emulation from
Target Reset
Note
3-6 In-Circuit Emulation
You can specify that the 7750/51 emulator begins execution from target
system reset. When the target system RESET line becomes active and
then inactive, the 7750/51 emulator will start reset sequence as actual
microprocessor.
To specify a run from target system reset, enter the following
command:
run from reset
The status now shows that the 7750/51 emulator is "Awaiting target
reset". After the target system is reset, the status line message will
change to show the appropriate emulator status.
In the "Awaiting target reset" status, you can not break into the
monitor. If you want to exit this status, you need to enter reset
command.