Table of Contents
Advertisement
run from transfer address 2-17
selecting internal clock forces reset 4-4
setting up emulation pod for target interrupts 3-5
Setting up the pod to accept target interrupts 4-16
software breakpoints in internal RAM 2-21
software breakpoints not allowed in target ROM 2-21
software breakpoints only at opcode addresses 2-21
target system must have clock circuit 3-5, 4-4
turn on target system before turn on the emulator 3-2
O
on-line help 2-8
P
PATH, HP-UX environment variable 2-5
pod_command 2-9
help information 2-9
predefining stack pointer 4-8
prerequisites for using the emulator 2-2
probe cable installation 3-2
processor mode register
defining the location A-4
processor operation mode 4-8
Purpose of the Emulator 1-1
R
real-time execution
restricting the emulator to 4-5
registers
display/modify 2-25
release_system
end command option 2-32, 4-20 - 4-21
reset (emulator)
running from target reset 2-17
reset (reset emulator) command 2-31
respond to target system interrupts
emulator configuration 4-16
restrict to real-time runs
emulator configuration 4-5
permissible commands 4-5
target system dependency 4-5
ROM
mapping emulation or target 4-12
writes to 4-13
Index-7
Advertisement
Table of Contents
